pushrods for magnum head conversion

Hello DusterBoy15;

A word of caution check your head to push rod clearance. I needed to
grind the area around the head partiing line. I recommend to install the
cylinder head on the block and before final assembly to check pushrod to
cylinder head clearance. Grind as needed.

I am using 1.6 rockers with the crane cams magnum guide plate system
and boss 302 push rods. Cycle the engine one rotation and check the push
rod and location of the rocker tip to valve stem relationship. The rocker
tip should be centered on the valve stem tip.

The heads are very efficent you won't need to push timing past 34 deg.
total. Depending on your combination as much initial timing as possible.

Denny