4 Speed Conversion

I did the 4 gear swap in my 69 Dart. Place the hump on the tunnel, it pretty much aligns itself in position. Mark the perimeter of the hump on the floor and measure 1.5" to 2" inward and cut the hole. This'll be a good starting point without cutting out too much. Mount the bell, mount the shifter mechanism to the trans, install the trans, bolt in the crossmember, and install the shifter handle. Lay the hump and console in place then mark the exact location of the hump. Then trim out the hole in the floor accordingly for clearance of the shifter rods, leaving a bit of overhang inward welding and seam sealer.

You know the console shifter is different from the norm. It has all of the funky bends.