I don't know if this is the right spot for this or not. I'm going to the dyno on the 21st of this month and was wondering if all of you could maybe do some guessing on my (hp and tq) ratings just for fun and then when it is done I will post my sheets. Here is what I got 77 360 debured and smoothed, .30 over, KB190 pistons 10.5 to 1, moly rings, stock rods floated and stock crank .10 on both, windage tray, standard oil pump, stock oil pan, no oil passages enlarged or plugged, MP 284-484 installed straight up, MP lifters, mancini tru-roller timming chain, mancini stock length push-rods, milodon valley tray, J-heads very light porting completly smoothed and debured 2.02-1.60 back cut on the intake valves, compcam springs installed at the right pressurse, stock rockers and shafts, stock 4brl intake port matched, 750 carb and 1" spacer.