Addco Sway Bar

The instructions that came with the bar are not the best.

Step 1. Pass the bar through the opening in the k-member.
(Does this mean over the brace that runs from the k-member to right below the radiator?)

Step 2. Bolt the adapter plates into the existing holes in the k-member. (No problem here) There is some more jibberish about connecting the bar to these adapter plates. (The bar has an arch to it in the center, does the bar arch upward or downward?)

Step 3. Assemble end links....

Step 4. Raise bar assembly and position the vertical leg of the angle bracket against front side of suspension arm, just inboard of rear end of the control strut. Mark the arm and drill with a 3/8" drill bit. (??? I thought the end links attached to the lower shock bolt?)

Step 5. Bolt the angle bracket to the suspension arm.