New Cooling/fan question
I run about 19 degrees at idle, all in 34 degrees about 3200 RPMS (so says Don at FBO. I have his ignition on there.
Anyway. I have the new fan setup on. Dual Mr. Gasket 12" fans, mounted via two pieces of 26" long angle aluminum. In these pics it's just mocked up with zip ties while I verify my drill points are correct. Currently it IS bolted up and the wiring has be redone with one weatherpack connector to run both fans.
Sunday, I should the new water pump, coolant and waterwetter in. While in there I am also going to replace a header stud (currently using a bolt, but it goes in the water jacket) and installing copper header gaskets.
I run about 19 degrees at idle, all in 34 degrees about 3200 RPMS (so says Don at FBO. I have his ignition on there.
Anyway. I have the new fan setup on. Dual Mr. Gasket 12" fans, mounted via two pieces of 26" long angle aluminum. In these pics it's just mocked up with zip ties while I verify my drill points are correct. Currently it IS bolted up and the wiring has be redone with one weatherpack connector to run both fans.
Sunday, I should the new water pump, coolant and waterwetter in. While in there I am also going to replace a header stud (currently using a bolt, but it goes in the water jacket) and installing copper header gaskets.