anybody running buckets that aren't out of an old mopar?

Anything can be "made to fit" with enough fabrication. I'm running 99-00 dodge avenger seats in my duster that have all mechanical adjustments. They only share one bolt hole with the original seats..
If I had it to do over again I would use something that fit a little closer to begin with. I would start by measuring the passenger side floor board in between the trans tunnel and the outer mounting hump and from the first step up in the front to the step down in the rear, then measure seat height ( the butt part ) front and back. The reason I say passenger side is that the trans tunnel is closer to the pass side than the driver side.
After that visit your local pick and pull with your tape measure and start looking for seats that fit the measurements... :thumleft:
I understand that I will take you a while to find something you like and fits, but it's FAR easier than getting some awesome seats only to find that you have to transplant the floor from the car they came from to get them to fit.