rumblefish's Duster project
Well, it's been a loong time, and I have done a little something, here we go, on our way........
The nearly finished passenger floor pan. Gotta get where the feet go done. On the outside of the car, underneath of course, I need to tack weld up a few spots and apply seam sealer. That's it. Almost done there!
Then the drivers side, ran out of light today, but fido's a$$ welding is getting better. I'll finish up the rest of the spool of wire tomorrow and hope it's enuff to seal it and paint it up.
Ahhh, the new rear pans. After I get a new spool of wire, they'll get washed and welded in. I'll mark and cut out the rear section tomorrow before the fire works.
They also came with.. a carpet and dash cap. Now I need some box tube so I can use it to mount in a set of Chrysler Concord seats from a 2001 or 02 I had breifly.
I think the hardest part of it all will be the shifter. It'll have to come out and get mounted back in over the carpet.
Well, it's been a loong time, and I have done a little something, here we go, on our way........
The nearly finished passenger floor pan. Gotta get where the feet go done. On the outside of the car, underneath of course, I need to tack weld up a few spots and apply seam sealer. That's it. Almost done there!
Then the drivers side, ran out of light today, but fido's a$$ welding is getting better. I'll finish up the rest of the spool of wire tomorrow and hope it's enuff to seal it and paint it up.
Ahhh, the new rear pans. After I get a new spool of wire, they'll get washed and welded in. I'll mark and cut out the rear section tomorrow before the fire works.
They also came with.. a carpet and dash cap. Now I need some box tube so I can use it to mount in a set of Chrysler Concord seats from a 2001 or 02 I had breifly.
I think the hardest part of it all will be the shifter. It'll have to come out and get mounted back in over the carpet.