DIY quarter skins

well here is my story LOL they make a drill with a out side cutting bit just for spot welds. the task you are about to enbark on is not easy this is where you learn paitence you got to have getting mad is not going to work take your time and it will turn out good. i used Year one panels and was not to inpressed the trunk was stamped crooked and the lower rear 1/4 was not molded all the way in the rear so get them some where else i did the trunk first so i had a guide by the outer skins then i replaced the skin i agree with waggin only replace what you have to i also cut the middle not on the body line some are even glueing the panels on now instaed of welding so there is no welding but i couldnt bring myself to do it (old school !) just make sure you dont overheat the metal it will warp easy so take your time. if your going to do the back frame rail when the trunk is out is the best time but you will ahve to support every thing to make sure it don't move while you are doing it use some square tubing and weld it inside to hold every thing square and the tail dont drop on you you good luck