Electrical project: Done

OK...almost.....I'm still putting zip ties and cable looming on, but the wiring work is done.

- Installed a Buss bar in the engine compartment.
- 4AWG charging wire installed
- dual 6AWG power wires ran through fire wall for power to car
- Maxi fuses installed for dead-short protection on 6AWG wires
- bypassed all original bulkhead main power wires
- installed direct power relay for fuel pump
- installed power switch to drive relay, ran from ign power
- removed & spliced old harness connector by blower motor
- shortened coil wires by 10" (and replaced nicked wire completely)
- installed 14AWG sense wire from regulator to buss bar
- 6AWG power, starter relay, and sense wires are hooked to buss bar
- fuel optimizer wiring removed
- all old pollution wiring removed

The battery is connected via 4AWG cable to buss for now. It's a short term setup until the battery goes to the trunk. I can post a pic or two if anyone actually cares to see the setup....

All that, and I didn't even blow anything up:thumbrig:
Hopefully it will be on the street soon.....:burnout: