Mufflers
I had that problem... What I did was welded a piece of 3" pipe, about 18" long to the reducers and had them bent in the middle, so they have about an 1-1/2" drop. Then my bullets are welded to the end of those pipes. The end of the muffler is about where the rear of the door is. I had to have the turndown turned sideways so they don't get jammed when I take the car off the trailer.
You can see one in this pic (on the right):
AdamR said
I had that problem... What I did was welded a piece of 3" pipe, about 18" long to the reducers and had them bent in the middle, so they have about an 1-1/2" drop. Then my bullets are welded to the end of those pipes. The end of the muffler is about where the rear of the door is. I had to have the turndown turned sideways so they don't get jammed when I take the car off the trailer.
You can see one in this pic (on the right):