? Valvetrain Geometry ?
I thought i might update this thread a little,now that i have my heads apart.
The following pictures are the rocker just sitting on the valve, 1/2 of total lift and full lift,which on this cam is .549
As you can see the rocker starts in the middle and rolls almost to the edge.
This is what the tops of the valves were looking like.
If i were to grind the valves,with the margins being so small on these, I think that would further compound my problem. So i did a little checking and found Milodon offers a valve that is a little longer than stock. I don't remember the exact dimension,i left the book at the shop.
Haha,no such thing as just bolting parts on ehh
I thought i might update this thread a little,now that i have my heads apart.
The following pictures are the rocker just sitting on the valve, 1/2 of total lift and full lift,which on this cam is .549
As you can see the rocker starts in the middle and rolls almost to the edge.
This is what the tops of the valves were looking like.
If i were to grind the valves,with the margins being so small on these, I think that would further compound my problem. So i did a little checking and found Milodon offers a valve that is a little longer than stock. I don't remember the exact dimension,i left the book at the shop.
Haha,no such thing as just bolting parts on ehh