Any step by step instructions on converting auto-4spd?

As far as cost goes, it really depends on how much time you have to gather the stuff. Or what just falls from the sky
Now this might be a little less than a typical conversion b/c its for a /6 and it's going to be COMPLETELY custom but if someone has the time to wait it can really save some cash

here is my list of stuff. (DON'T forget about the little things like paint and misc bolts)
So far I've got:
4 speed 87 /6 van trans with shifter- $50 from craigslist
pedals, bell with fork, flywheel, clutch plate, pressure plate, z-bar with rod - $170 from an unnamed member ;)

I still need:
727 yoke - cost unknown
driveshaft shortened/balanced - $70 priced from local driveline place
pilot bearing $5 - from the local parts place
Throwout bearing $30 - from the local parts place
pressure plate bolts
hydro clutch setup - $50 - by the time I get it all figured out (I'm missing the bellhousing z-bar stud.)
Shift rods - cost unknown - probably custom due to shifter location
The floor hump will also be a custom piece because I'm trying to keep the shifter as close to the center of the car as possible.

So maybe $450-550 for the whole setup....BUT... a lot of time getting things ready. and I still need to figure out the wiring for reverse lights and neutral/clutch starter lockout