Holley Help Needed

Thanks for the quick reply Rumble...The cam specs are Dur @ 50...214/224 V/lift 444/467 it is a dynotec cam part number CM371D...Was thinking that the 600 vac was going to be to small but I only just got the motor in & running yesterday & not much time left to get ready for the drags I was hoping to use the carb I have till after the race meet then I was going to get another inlet manifold & carb.

...As for compression it would be around 8.5to1 or 9to1 basicly standard.

I'm using a single plan as I plan to take it to the strip this weekend.