ARP Studs: Torque?Lock-Tite?

this is from the ARP instructions, i can fax them to you if you want.

this is for 1/2 diameter studs with 190,000 PSI

Hand tighten studs only, Lock tight may be used but torq must be completed prior to the lock tight set up.

With Moly lube 90LBS
with 30 wt Motor oil 130LBS

Be prepared also that the studs may throw out you thruste bearing clearance so you may have to take the bearing down a bit make sure you pay close attention to that area trust me. you will need about .006 on both sides so make sure you check.