t5 trans swap?

gmachinedart1 said

You are correct ,you will need a 10.5" ford 10 spline disk.As far as the p/p is concerned it depends on what type of throwout brng/linkage setup you decide to use.I had to use a GM p/p for a hyd brng application because the hyd brng dictated it ,but if you go with the std mechanical brng you can use a std mopar p/p.

justin

Click to expand...

hey justin, got my quicktime bellhousing (the clearance one thats non sfi approved) and after some worrying about whether or not it will work with the mopar mechanical linkage, i found out it will...im starting to understand this swap alot better now...How is your swap coming along? any progress as of late? pics?..I have another question- i think fstfish66 mentioned this earlier in the thread, but since im going to be using mopar mechanical clutch linkage with mopar flywheel and pressure plate and ford disk, what kind of throwout bearing would i use? would it be a mopar one or a ford one? I think it was said that i could use the mopar throwout bearing, but i wanted to double check that...I think im going to look into the Mcleod stuff for clutch and flywheel, since they came back under their old management and are lowering their prices considerably.