Pro Parts header install / RB in a '69 Barracuda
I have the same headers on my 67, a real pain in the a$$.
Some of the things I did to ease the pain.
On the pass side I used a 4" hole saw to put the whole in the fender well. I made a cover to dress it up after header was installed.
Drives side was trial and error untill I got the clearence needed. Where that tube is hitting the shock tower the metal has to go, I trimed that out also with a cover. Hint the drivers side is going to hit the pitman arm, it will have to be dented for clearence before final install.
My header collectors did not have the flange on them so clearence at the trans cross member was not an issue.
Last of all as you slide all this together use a LOT of anti siese compound when sliding all these tubes together.
I also had to eliminate the stock steering coupler.
I wish you well, at least for me the I'm satisfied with the finished product.
I have the same headers on my 67, a real pain in the a$$.
Some of the things I did to ease the pain.
On the pass side I used a 4" hole saw to put the whole in the fender well. I made a cover to dress it up after header was installed.
Drives side was trial and error untill I got the clearence needed. Where that tube is hitting the shock tower the metal has to go, I trimed that out also with a cover. Hint the drivers side is going to hit the pitman arm, it will have to be dented for clearence before final install.
My header collectors did not have the flange on them so clearence at the trans cross member was not an issue.
Last of all as you slide all this together use a LOT of anti siese compound when sliding all these tubes together.
I also had to eliminate the stock steering coupler.
I wish you well, at least for me the I'm satisfied with the finished product.