360 build

This thing is going in the car thanksgiving weekend so Im going over everything about 50 billion times.
In the book "How to hot rod small block mopar" by hp books they say to torque the rocker arm shaft bolts to 30 ft lbs. I have a brand new torque wrench and at 30 ft lbs. the rockers seem like they are too loose (I have hydraullic lifters). Am I just paranoid?

Oil pick up tube, 1/4 inch from the bottom of the pan right?

#1 is at TDC, oil pump drive gear is in, the rotor in the mock up dist. is pointing at the first exhaust bolt (stud) on the driver side, the crank gear is a 3 way (-4, 0, +4) and is set at +4 (see pics in link, 360 folder), all the oil passage plugs that need to be in are in.


http://pg.photos.yahoo.com/ph/scamp_of_doom_73/my_photos

Oil pan gaskets, I have a stock FelPro cork set and one of the summit
PN SCE-269091 one piece reuseable gaskets. I have never had a problem with the stock ones should I just go with them and save the summit piece for the "go fast" motor for my 27 T.

I think Im ready to install the pan, intake and valve covers.