push rods

homeboysduster said
i'm sure you all know by now that this is my first "real" performance motor. i really want to make sure that i get it right the first time!!!! so let me get this right 4 rockers installed on the corners using solid lifters. use a push rod checker on all 4 corners. and measure. then measure again, then measure again. (i like to triple check). i should be ready to order the push rods!!!!:wav:

Yes one rocker set up at each corner of the motor. This makes sure that you get the proper length in case the block as been milled or heads and if there are in difference in length between the four you will catch it now. Have you tried set up yet with your stock push rod? Do so and take a picture of the rocker and valve (like I did) to show everyone if you can.