Check out these custom A body clusters.

Cudapaz. For a long time I was thinking of getting the RMD panel. At least until they went out of business. Then I got an idea. I called Mike at BEA up and ordered a new repop dash from him. I decided to use this dash, ordered up Autometer Artic White gauges and built my own dash. In the large right pod, I bought the quad gauge that has fuel, volts, oil pressure, and engine temp. In the large left pod, I installed a speedo, and in the center pod went a small tach. The problem of course is that the Autometer(and all gauges) are smaller than the pod sizes. To get around this, I took my old dash apart, pitched the plastic lense covers, and used the old bezels that the old gauges mounted too. These bezels are metal but still the wrong size. With a trip to the hardware store, I was able to by some snips and 22GA sheet metal. I cut out a piece of metal to fit the inner diameter of the old bezels and then cut that piece to barely fit the outer diameter of my gauges. I epoxied this filler piece onto the old bezels and painted everything flat black, then epoxied the bezel onto the BEA dash. A persons eyes are automatically drawn to the gauges and I have found nobody even notices what I did. I have had 4 guys over to the garage just to give me feedback and everyone swears it looks better than factory. Now it did take a little work, but Wow is all I can say. Just and idea as I know you and I are at about the same spot in our restos.

Kirk