'64 Valiant V-200 parts list! (Vancouver)

Traikun, unless you're looking for perfection, those rear floor pans are very easy and cheap to make. I made mine and was surprised at how well it worked out. I laid a piece of sheet metal over the rust hole, laid a trash bag in the area and made a mold out of bag concrete. Put a hook in like you use to hang up rakes and shovels so you have a way to get hold of it to get it back out. Let it cure for several days and then roll it over on the floor and cut a piece of metal a little bit bigger than what you need. Use a seamstress tape measure to get the dimensions. Make cuts in the metal roughly to where the "corners "will be. Put on some knee pads and roll it with one hand and wail on it with a rubber hammer with the other hand. You only need to get the bend started. Put it back in the car and stand in the middle of it with both feet so the corner cuts over lap. Make sure the pan contacts the frame members underneath the car. That is very important. I made that mistake and had to grind one back out.