Rear Firewall
Here is the next step at the back of the cockpit.
Addressing the issue of safety:
When I did the minitub I also set it up for a rear firewall composed of two sheets of metal with 3M 'Firestop" insulation between them. After I raise the tranny/ driveshaft tunnel, I will replace all the temp sheet metal screws ( poor mans cliko pins) with pop rivets. All penetrations through the wall will be in bulkhead connectors with intumesent caulking around the wires. I will also be putting sheet metal behind the sail panels to close off those openings as well as making cans for the speaker locations.
Andrew
Here is the next step at the back of the cockpit.
Addressing the issue of safety:
When I did the minitub I also set it up for a rear firewall composed of two sheets of metal with 3M 'Firestop" insulation between them. After I raise the tranny/ driveshaft tunnel, I will replace all the temp sheet metal screws ( poor mans cliko pins) with pop rivets. All penetrations through the wall will be in bulkhead connectors with intumesent caulking around the wires. I will also be putting sheet metal behind the sail panels to close off those openings as well as making cans for the speaker locations.
Andrew