Electronic ignition upgrade / voltage regulator question
This thread hasnt been active for a few weeks so I dont feel as bad about hijacking it briefly.
I found my Summit CD ignition system was not putting power to my plugs when the starter was engaged. Based upon the diagram and discussion in this thread, Ignition #2 would seem to solve my problem. I am just having a problem identifying which wire it might be. Could someone take a look at the picture and point it out to me? I was previously connected to the wire with the tape on it.
In the alternative, I dont seem to need a ballast resistor any longer. Would I be better off just removing it and connecting all the wires together? Possible coil damage would seem to be the only reason not to. I am running a Pertronix Flamethrower I coil if that matters. Thanks.
This thread hasnt been active for a few weeks so I dont feel as bad about hijacking it briefly.
I found my Summit CD ignition system was not putting power to my plugs when the starter was engaged. Based upon the diagram and discussion in this thread, Ignition #2 would seem to solve my problem. I am just having a problem identifying which wire it might be. Could someone take a look at the picture and point it out to me? I was previously connected to the wire with the tape on it.
In the alternative, I dont seem to need a ballast resistor any longer. Would I be better off just removing it and connecting all the wires together? Possible coil damage would seem to be the only reason not to. I am running a Pertronix Flamethrower I coil if that matters. Thanks.
