8 1/4 Gear Change Question

I am going to be doing the same things to my 8.25 within the week, I finally managed to get all the bearings off - long story. I hollowed out the old pinion bearing to use for setup. I have several questions though.

1. Since I failed to pay attention to the direction of the adjusters when I took them out, I'm assuming they go back in with the hex hole toward the outside/ wheel? Also, what's the torque setting for these adjusters?

2. I have 2 sets of 3.55 gears, can I use the pinion off one and the ring gear off the other if they're both Chrysler units, in other words, are they interchangeable?

3. Does anyone have a picture of a known GOOD ink pattern for these rears, esp with 3.55s?