68 barracuda trim removal

The windshield trim tool is shaped like a hammerhead shark. Place the tool flat against the glass and slip the head of the shark under the trim, locating the trim clips by sliding what would be the "eye" of the shark under the edge of a clip. Keep the nose seated and pivot the head, rocking the body right or left to free the trim from the clip.
The drip mold is removed from the bottom only. Remove the corners that are at the junction of the two pieces at the A pillar. Remove by hand if possible but if not a flat screwdriver can be used, from there, put on a good pair of gloves and work the moulding off by lifting it from the bottom and rolling it upward. Again if you have trouble starting it you can use a screwdrivew but don`t go beyond what the corner will cover. There`s a small lip on the bottom of the moulding that retains it. Use nothing but your hands if at all possible when removing it and that`ll prevent beating it up. HTH.