Tincup's 63 Dart w/5.7 Hemi

rjsjea said

That's what I used. I bought them just tacked together in case they needed to be modified. The one thing on my car I actually lucked out on........they fit perfect.

I have heard the Jeep SRT8 headers are much tighter to the block and may fit better than the car version....they are different.

Click to expand...

Thanks RJ, that's what I have is the Jeep srt8 manifolds. I did some test fitting last night and I think they are going to work fine. I do have to notch my drivers side motor mount to make them fit, but what else is new.

I do have a favor to ask, have you put your tranny in yet? If not could you take a measurement from the center of the input shaft to the bottom of the base. I'm trying to figure out how low it's going to hang compared to my 545. I'm trying to get this thing down as low as I can go, and this trans looks kind of low. I haven't bolted it up yet, but just in case, I would like to check my options. Thanks.