A-body Big bolt pattern Axles ??

i just bought a set of yukons off of ebay, very impressed. great quaility. i used a set of drums & backing plates from a 1970 challenger 10 X 2 1/4. the only problem i had was from the guy i got them from. he supplied me the green wheel bearings & moroso wheel studs. the studs will not fit, the axle hole measures .650 & the moroso press in studs are .685, which i should have known better. i did try to press one stud in, as i was assured they were right, well i have a 20-ton walker press & these were not going in. this gentleman is known as Mr. Wolfe. i have tried to contact him, with know luck. the studs he sold me cost $50.00 including frt. i went down to my local NAPA store & got a set of MR. Gasket wheel studs, part number 4311, & they fit perfect!they only cost $20.00! MR. Wolfe does offer to install the bearings & studs at an additional cost. but as far as these axles go, i have owned Moser & Strange axles, and these look as good!