Front end rebuild kit with 73 and Up stuff!

Well, I had to drill the fifth bottom bolt. The other four were the same. Then I machined a little in the inner circle of the caliper bracket to take the green bearing for the 8 3/4 rear end. Basically that was it. The only thing that I didn't compansate was the how thick the rotor was. So once I was done the hole width of the rearend was like a 1/4 inch wider. Being an 1/8 on each side. I thought that I was taking everything in account when I machined the caliper braket to be as thick as the old back plate for the drums. Which put the axles flanges back where they were, but the rotor is thicker that the drum so that put the wheels an 1/8 out on both sides. I've got pictures, but I haven't got them scanned yet.

Lee