Fiberglass hood mods... crazy?

ta3834bbl said
Truck without cover means wet tools. lol jk

I think you should vent the area just in front of the firewall out the side of the fenders like a (pardon the french) trans am did in the 70's and 80's. Place them as low and as far to the rear as you can behind the wheel. I don't think too many people would be looking there on a 4 door car, so it wouldn't be that obvious, at least not as obvious as a hinged hood. Paint it body color and have some fun. Make sure to use ducting / tubing from the fender well to the vent or the air in the wheel well will mess this plan up.

What do you think?

I actually dont think this is a half bad idea either....you could do as mentioned and put in louver venting on the sides of the fenders or you could be indiscrete about it and cut your holes at the bottom the fenders on the underside facing the ground,so that all would appear to be stock but you would still be able to exit the pressure and heat in the engine bay via the ducting from the bay,through an opening into the fender well and exiting the bottoms of the fenders.

There tons of various ways you could go about it.

Now its just a question of which way lol