,knowing this you should be able to stack measurements and arrive close to a # for the other set-up.I don't think the motor knows or cares if you use clay or not after it will be the same measurement.
ah...i just re-read this part....OK..i see your point now.
i can use my current cam profile as a base to check for values that are known.
then measure off of this to see if that allows for more clearence ..and where/at what point?
i can configure a profile or new profile ....
thats interesting...
if its installed at 107...which this cam is..
i can account for this also...
Ok i got more work to do.
thanks
Mel.