My 67 Dart, Where to begin...
Next I used a pneumatic chisel/hammer to "connect the dots" i made with my drill. I snuck the chisel between the frame to cut the pans there also. A grinder or cut-off wheel is perfect for nipping the last bit of pan over the rails.
I used the chisel to push the pan away from the frame, I eventually switched to a pry bar to just "snap" some of the spot welds, which was easier than the chisel. I then did the same at the seam along the top of the panel.
Next I used a pneumatic chisel/hammer to "connect the dots" i made with my drill. I snuck the chisel between the frame to cut the pans there also. A grinder or cut-off wheel is perfect for nipping the last bit of pan over the rails.
I used the chisel to push the pan away from the frame, I eventually switched to a pry bar to just "snap" some of the spot welds, which was easier than the chisel. I then did the same at the seam along the top of the panel.