Idler arm hits on header

I would just like to say again though... If you figure out the process it's not that bad, and they do fit.
A lot of people (including me) complain about these headers not fitting correctly and how much they suck. Someone just needs to post good directions to make it easier for people, so they don't have these problems.

I'd do it, but I'm not sure I remember. I was on fire though! :angryfir: by the third try it was cake.

I even remember there is a order in which the bolts should go in first. I think the last two on the end, and the second one.
Put the starter in, and the battery cables first before you bolt on the header.
and have the tie rod and idler arm connected before you hook up the headers too. I didn't do that, and I REFUSED to take the headers off again!
I had to pretty much force the tie rod on the idler arm, because there was no room! It sucked!

Thats what I remember for now.