The Darwin Project
Got the floors in and welded. Patched a small hole in the trunk floor right above the bumper mount, thats the only rust in the trunk area. A little grinding and seam sealer and I can start prep on interior for paint. Reinforced the rear cross member, it was rusted pretty thin around bumper mounts. Used 1/16th" steel plate, didn't want to go too thick 'cause that might pull the bumper out away from the body.
Took a break from welding and started sanding on the left rear quarter panel for about an hour.
I'm gonna try to get it sanded ironed out and into primer by thanksgiving.
Got the floors in and welded. Patched a small hole in the trunk floor right above the bumper mount, thats the only rust in the trunk area. A little grinding and seam sealer and I can start prep on interior for paint. Reinforced the rear cross member, it was rusted pretty thin around bumper mounts. Used 1/16th" steel plate, didn't want to go too thick 'cause that might pull the bumper out away from the body.
Took a break from welding and started sanding on the left rear quarter panel for about an hour.
I'm gonna try to get it sanded ironed out and into primer by thanksgiving.