serious street power.

Well ok.. Basically the rest of my set up is ok.. to me at least.
about 2800 converter... 3.91 gears And the heads have had a valve job and better locks and retainers installed.

I figured that since my bearing/rings/seals need to be replaced anyways since the motor has never been torn apart and to go any bigger cam in the future if i wanted too pistons too.....
I figure i could spend about $2000 out the door for my shortblock to get cleaned/flauxed/bored .030 over and put the new stroker bottem end in....
Then put the heads back on or maby if any money is left over(not likely)
and then the new pistons w/valve reliefs leave room for bigger cam in the future when more money comes....
As for budget..... tighter then a 500lb mans pants.... small pants too.
I dont have money but i will be spending most of my tax return on this so i rather just go big and get a stroker kit.
as for other parts...intake and stuff.. not changing. anything else on the motor is there for a reason.