HELP!!!!! 71 Dart swinger dash removal

I took the entire dash out and stripped it on the sawhorses. i did not take pics but it is a pain. make sure you lable every wire connector as you unplug it. this helps when re-installing it, I'm still trying to find connectors.
Not sure how far you have gone so Where do I start?
1-i unbolted 4 steering colum bolts at the floorboard that will let it drop. I found that if the wheel is sitting on the seat you should have enough room
2 Un-bolt the e-brake handle from the dash 7/16 nut on the back side or slide the pin from above the handle. let it go down to the floor
3- loosen the bolts on the lower side where the kick panels would be. just loosen them as the dash will pivot down on them
4- un-bolt the 5 bolts along the front of the dash. 3/8 i believe. swivle the dash down.
5- now the hard part- LABLE ALL WIRES. (Let me say, I wish I were by myself in this part. One I would not have been drinking and two I would not have been in a hurry.) take plenty of pics. DO NOT unplug everything you see. Not all the connectors go to the dash. I would start on one side and work to the other. there are clips along the bottom of the dash that hold the wires, pull all the wires from there so that you can tell which go to the dash and which just are there and for under the dash. Once you feel that all the wires are labled, check again.
6- woodgrain around radio\heat controls. there are 2 nuts that need to come off to pull the controls off the dash. You will see which they are. Don't worry about taking off the woodgrain yet. Once you have it on the bench\ horses or wherever you can take that off.

WOW, if you need more help just PM me. I am still trying to get my map light and glove box light working. But I just completed the install. so fresh in my mind.
Now have a buddy help you pull the dash out of the car.