Stock Seats and Cage/harnesses question

Hey Guitarjones and crackedback,

Id definatly rather not bolt the seatbacks, but i have been told this by many (although i still have to check with my local track)...As far as cutting the slit in the headrests for the shoulder harnesses I am aware of that and will be having that done (Does it matter how high below or above the shoulders the belts have to pass through?)...The only reason I was even worried about all this is because of that section from the rulebook i posted in my original question it says must be secured to the crossbar, so i thought it had too...also, where can i find the stock eliminator rules without paying for them- are they online?

As far as the rear bars go i agree guys about letting them run as far back as possible...I actually really like the way my dad ran them, although the picture crackedback posted does look like a more ergonomical way in terms of having backseat usage (as long as they arent tall)...Although its hard to see in the original pic i posted, my dads bars cross and run all the way to the back of the trunk and are welded with plates to the frame for maximum rigidity and i agree if your going to do it go the extra mile and do it all the way.

Like i said, this is all for future just to make sure i dont spend money recovering seats and then have to do it a couple years later for when a cage goes in since i aint made of moeny (none of us are)...Yes this car will get driven alot on the street, but most of the time it will be me and a passenger if that, so im not too concerned about lugging a full family for a vacation