Tincup's 63 Dart w/5.7 Hemi
OK time for an update. The underside is finished, so I started stripping down the body. I'm looking forward to getting the body straight and ready for paint. I finished prepping the engine compartment, finished sanding the epoxy, then threw some etch to cover the bare metal spots, then I shot two coats of K36 urethane primer (no pic). As you can see I uncovered a little surprise in the drivers door. Apparently the factory undercoat pealed away and made a place for water to sit, and make holes in my otherwise perfect door. Oh well, whats another couple holes to fill, as you can see, I have quite a few to get rid of, ( all the moulding holes and the door handle and lock are going). I had to weld up the holes for the mirror, because they were about 5 sizes to big, plus the door was all dented where the mirror goes, so I'll just drill some new ones later on.
OK time for an update. The underside is finished, so I started stripping down the body. I'm looking forward to getting the body straight and ready for paint. I finished prepping the engine compartment, finished sanding the epoxy, then threw some etch to cover the bare metal spots, then I shot two coats of K36 urethane primer (no pic). As you can see I uncovered a little surprise in the drivers door. Apparently the factory undercoat pealed away and made a place for water to sit, and make holes in my otherwise perfect door. Oh well, whats another couple holes to fill, as you can see, I have quite a few to get rid of, ( all the moulding holes and the door handle and lock are going). I had to weld up the holes for the mirror, because they were about 5 sizes to big, plus the door was all dented where the mirror goes, so I'll just drill some new ones later on.