How Do We Install Rods That Go In Front Of Hemi Dart Scoop?

The one I had , had 2 thread inserts glassed onto the top of the scoop from the inside. They were kind of hard to see at first because they got a little sloppy with the resin. I went and got a piece of 1/4 " allthread and cut them and screwed them into the thread serts with lock tite . then bought a piece of aluminum tubing that fit the all thread. drilled 2 holes in the hood to run the allthread thru. slipped the tubing on and threaded a nut on the underside of the hood.

Note: be sure to leave a little extra length under the hood as you want to be able to adjust the front lip of the sccop to be level. After sitting in the hot sun and getting some sag in it plus bowing from catching air at speed the fiberglas will eventually start to droop and bow in places. You can make adjustments to keep it straight and sharp looking