Picture time! Show off what pressurize's your engine!
this lyshom twinscrew will end up in this
hopefully i will make 15lbs of boost before the block grenades, but only time will tell..
340 .030 over with milled down TRW pistons,stock forged crank, eagle H beam rods and an old 1050 holley dominator my old dead 340 will suply some ported out edelbrock heads, and a fairly small solidroller cam 242/248 at .050 with .570"/.576" lift will probably make some 2" headers with 3½"collectors
i hope this will make enough torque and horsepower to be at least alitle exciting for alitle more than the normal 5minutes of excitement i usualy get from the power of a new built motor (this should be close to 600hp from what i can gues and if i can get the money togheter in time to dyno it i will now for sure how much power it makes)
this lyshom twinscrew will end up in this
hopefully i will make 15lbs of boost before the block grenades, but only time will tell..
340 .030 over with milled down TRW pistons,stock forged crank, eagle H beam rods and an old 1050 holley dominator my old dead 340 will suply some ported out edelbrock heads, and a fairly small solidroller cam 242/248 at .050 with .570"/.576" lift will probably make some 2" headers with 3½"collectors
i hope this will make enough torque and horsepower to be at least alitle exciting for alitle more than the normal 5minutes of excitement i usualy get from the power of a new built motor (this should be close to 600hp from what i can gues and if i can get the money togheter in time to dyno it i will now for sure how much power it makes)