too mild camshaft

mopar340dave said
you don't wanna here this but,,,,your static comp is possibly too low to take advantage of the rest of the combo...I would want around 12-1 static with a .630" lift solid roller, like 26? duration at .050"

carcraft/Steve Dulcich used this to do it, I think:
http://cranecams.com/?show=browsePa...-360 C.I.&partNumber=698811&partType=camshaft

you need to calculate your dynamic compression ratio

Whatever they did, If they dyno tested it at the happy westech facility you can throw the data in the trash or multiply it by about .85-.87 to get the REAL numbers. Seen more than one engine dyno run at westech and then at another facility. It ran the MPH consistent with the lower numbers.
----------------------------------------------------------------

For the OP. I'd only be concerned with the numbers at .500-.550 and below. What your heads flow at .650 isn't of concern when the cam is only opening a gross number .050 below that number. Figure lash and bad valvetrain angles and it's much less at the valve, likely a net of .550-.560 if you are lucky with the 1.6 rocker.

That cam works pretty well in stroker set ups