buckets and center console

I am going to rip out the original bench seat and install my eBay bucket seats and console this weekend. I got the seats cleaned up last night. Shampoo'd and then steam cleaned them. They don't look too bad, but will need to be re-upholstered at some point. I'll start cleaning up the console tonight.

Anyway, from what I've read, the two outside holes for the bucket seat sliders should line up with the holes for the bench seat. And I will only need to drill the two inside holes for each seat. Is that correct? Any gotcha's I need to be aware of? What about the seat belts? I was just going to remove the center set and leave the others.

Okay, now for the console. I don't have the mounting brackets, so I'll need to fabricate some. I also don't know where to position the console for and aft. Anyone have pictures or some measurements of a factory installed console in a Dart? How about pics of the floor pan with the console brackets installed? How are the console brackets attached to the floor? Welded or bolted? A pic is worth 10,000 words, so post 'em if you've got 'em.


:worthles: