whomp whomp whomp

FYI--I was running Brad Penn 10-30 in my stroker 410 and the oil pressure was low at idle around 22lbs or so at 1100 rpm warm. Blurp the throttle and it would go to 65 at around 2000 rpm. I switch oil to VR1 20-50 with Zinc that NAPA does not usually carry on the shelf and has to be ordered. My oil pressure is now 32 lbs at idle and right at 65-70 lbs above idle...........I also am running a Milodon Pan on a 360 block. I only put enough oil in it to BARELY touch the bottom of the dipstick.......which is right at 6.5 quarts of oil........I run it like that to keep the windage at a minimum. I am running a Hughes Girdle so I didn't run a tray. FWIW

Cold it is about 50lbs at idle and blurp the throttle it will hit 90lbs+, remember this is cold. So I dont revvvv it past 2k until it is a little warmed up. Ohhhhhhhh, I am running a Melling HV pump.