dodge29
Well-Known Member
6.1L SRt 8 6 speed Tremec, will it bolt up to LA block????
Dodge29
ps realize the forumn says 4 speeds, whats 2 more
Dodge29
ps realize the forumn says 4 speeds, whats 2 more
6.1L Tremec 6 Speed fitment question??
- Thread starter dodge29
- Start date
-
bjkadron
Well-Known Member
Yeah.. It will.. but you don't want to mess with it... Just send it to me and you can use a four-speed and not have to worry about the two extras. I even have a four-speed if you want to trade! ;)
toplscuda
Well-Known Member
Yeah that to both the replies. It would look much better behind the ^.1 going in my car than the 4spd I have.
On a serious note the one thing you may want to check is the input shaft length. I havent fitted the 4 gear uo to my 6.1 yet but have read that the 4 gear input shaft may require a slight trimming at the end due to the way the crankshaft is. That might mean the 6 gear may not reach fully in to the pilot bearing as it should.
On a serious note the one thing you may want to check is the input shaft length. I havent fitted the 4 gear uo to my 6.1 yet but have read that the 4 gear input shaft may require a slight trimming at the end due to the way the crankshaft is. That might mean the 6 gear may not reach fully in to the pilot bearing as it should.
dodge29
Well-Known Member
sorry guys have a serious cubed small block dying for it, 440 cids small block making better the 500hps+, the rear axle is an grand national 9 inch full float with bearcat bearings and cages....have a potential donor car....one way or the other want to go 6 speed, hoping that that i can take the complete assembly, right down to the slave cylinder,etc
Dodge29
Dodge29
bjkadron
Well-Known Member
Nice!
dodge29
Well-Known Member
thanks, here is the car soon to become something much more that it ever dream of being....
-
