it won't move....
Stupid error on my part.. my little notebook that I write all my capacities in I wrote 13 for the 904 and 16 for the 727... but I didn't write pints or qts... thats what I get for not paying attention.
Anyways the fluid is all good and in the correct quantity. No more leaking.
But it still won't go into gear no lunging nothing.
It's a re-man'd 904 w/ a B&M street/strip kit and a 2800 stall. Last transmission I did with the new converter I put the converter in and then let it idle through the gears for a while and it worked fine.
Could an incorrectly installed shift kit cause it to do this? wrong pressure to the wrong spot, which does nothing?
edit:
I also just checked to see if there is any fluid pumping through the lines to the cooler.. and there is none. Pump bad?