serious carb issues

JoeDust451 said

This carb was just rebuilt & it has sloppy shafts WTF, When i was rebuilding holleys i always re-did the shafts with new bushings, with those loose shafts, you'll never get that carb tuned in "right", you may get by, but it won't be right, plus it'll always stay out of adj., At this point, i would just get a Billet base & be done, there set up for 4 corner, there nice, & it won't have holes drilled in the blades.

Heres one. http://cgi.ebay.com/ebaymotors/HOLL...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

Click to expand...

hey Joe, your probably right about it never being "right" with the blades like this....today i had a tough time getting it to idle again and had to reset the screws once more. I emailed the builder asking him what to do next and if HE could send the billet base plate since in reality i shouldnt be having these problems, plus i paid for mods on the blades and such, so it should atleast not be sloppy...Ill see what he says and go from there...i really dont want to spend anymore money, but if it means the car will run better than i definatly will