67 Dart Build Triangulated 4 link & Mini Tub

Badart said
315's shouldn't be an issue with mini tubs. I am running 325's with a little bit of fender lip trimming and about 5/8" on both sides with no rubbing. Good thing these 4-links don't move. I am sure you know this, but measure at least 3 times then cut. LOL.

That is good to know about the tires, I do want the biggest that will fit!

Maybe you can get away with only 3 times measuring before you cut... Crap I am up to about 7 times haaaaaaa :-D I also made sure that the link bars were degreed parallel with each other. I fine tuned it by adjusting the shock tower slightly from where it was mocked up. I used my IPHONE that has a degree app in it. That stinkin thing is right on the money!

Before I tacked the link in place I swear I measured checked measured at least 10 times. I did snap lines on the ground before I took the rear end out that were parallel with the car in about 4 places and two going from about the rear bumber to the Bell housing area. I then sprayed them with clear laquer so they would not disappear on me. Everything was built to those lines to ensure the car would go straight down the road!

I am working by myself on this project. I stared at it for about 5 hours before I started taking measurements etc. I have about 20 hours more in it so far. So about 25 hours total. If I can pull of the Mini Tub in the same time I will be happy.