360 Balance Question

Aaron said
Is it hard to change out the inserts in the mounts? The local parts store has the whole mount (right) for 9.99. And left for 11.99. Or the inserts are about 4 dollars. Can the new inserts be put into the mounts without removing it from the engine? I have TTI headers, will these be in the way very much? I also want to change the tranny mount while I am at it just to be sure (as mentioned above). By the way, the vibration got worse (I've rebuilt the suspension also since this thread started), and today while driving down the highway the driveshaft came off (rear u-joint broke). This is what is promting me to replace these. I am also going to have new u-joints installed in the driveshaft, and have it balanced and checked out. Are there any good articles or instructions for replacing the engine and tranny mounts for my Duster? Sorry for the long post.
Thank You

my gues is that since your driveshaft came of because of the bad u joint you may already have found your vibrationproblem, on your question about replacing motormounts there is noway you will beable to change just the inserts without removing the mount from both the k frame and the engine, easiest way to replace the mounts is to unbolt your headers from cylinderheads (this will alow you to move the engine around some more) then with a with a floorjack and a big block of wood under the oilpan loosen the bolts thru the spoolmounts and then loosen the bolts going thru the mountingears on the engineblock then slightliy raise the engine with the floorjack and you will be able to get your motormounts out, it can be done with a motorlift also.. not realy hard to do but make sure the engine is safely lifted so you dont hurt yourself.. it takes some time but is possible :)