Welding body seams

Well, for starters, I don't have a tig setup, (wish I did). I've done this type of welding on my street rods with good results. I decides to leave a inner lip on my fender well joints to give me a little room to weld to. I use low heat with very small weld puddles, and lots of them. I do hate welding overhead however. Should have called my brother in law, a professional welder, but not my favorite person, to do the job right.... ( panels were from JC Whitney, and they are a poor fit). If this were a high dollar car, I would get the best full panel I could get.