Search results for query: *

So if say it is 2.45 , you said higher ratio gears will not bolt up but if I get the gears (3.21 or 3.55) out of a 96 or older they should fit?

I hope so. I try to treat people fairly and I think most guys trust me.

OMG

Starter side shield Wanted . Black or silver Not the hole starter covering string behind gear

You are a good man passing along deals to your customers. I am sure that many of them become friends as well.

Ok so much good info so much research to do an process, So with all the info so far would it be cheaper an easier to change out the gears in the 8.25 I have ,I have yet to clean it an open it but I also have my bets on it being 2.76 and if not sure grip I install it an change the gears ? I hope...

I will take them all tomorrow, so I can identify them and tell me which one it is. I have a partner and he tells me it is 201047.

Welcome to FABO, nice looking Dart.

Welcome aboard to FABO, nice looking Plymouth V100 170.

I had one of the HF units, I would not get it again. I'm not a HF basher, but the design was pretty poor. I've used Shelter Logic many times. They have one that's 12x26 or so that's nice and has optional side walls. No portable shelter will stand up to snow, high wind, or other extreme...

Here’s my flame tip Siamese looking like a sunny side egg.

pm sent

13.5 section on that wheel? How wide is that wheel?

Yeah, that makes no sense to me either. Clutching at straws maybe? I stand by the fact that 383s are pretty much useless. An oversquare engine should be able to rev like crazy but the factory 383 redline is like 5,200. What's funny about that though is the '74 360 redline is probably even...

My fierce warrior, on guard duty...

Thanks

actually a car modified for performance that is set up correctly can be very 'clean' running as most performance motors are more efficient burning a larger percentage of the fuel they ingest. so i don't know who both of you are but you're wrong.

Thanks

$43,832 in USA

KB pistons have coated skirt now, i ran them in my 360 for 10 years with a .030 top ring gap, i drove it on the street, and then it became just a race engine.

not all of those 010 blocks are 4 bolt mains. they're more likely to be but not for certain.

My knuckleheads

People, it's more than freeway RPM, it is torque multiplication, and a 273 doesn't have much to spare. 2.76 gears killed a 383-2bbl for me. Remember your 10 speed bike?

Assembly line correct (stenciling) on top of pads. $150 includes shipping with tracking and insurance.

something about forests and trees... with 273 2bbl backed by a 904 with 7.25 in a dart as a daily grocery getter, the answer is half a gnats ***. or practically nothing. swap it and roll till it pukes its guts out, rinse and repeat.

Ok , Thanks

It's nice when a good deal falls in your lap! :thumbsup:

Yeaaaaa, I own one. (E body)

So I have a factory 360 roller cam from a ramcharger in a 69 Barracuda and a 69 Dart GT with a warmed up 400. I have never had the chance to race myself. Both cars make about 425hp and the torque developes at the bottom end for the big block and at the top end for the small block. Both have...