Still looking for these clips or any that would work. Any help would be appreciated. I would hate to have one of these fly off while driving. See thread above for picture of clip.
In response to PM received. I believe the difference 70 vs 71-72. is the floor mounting flange. Someone correct me if I am wrong. This is both of my 71's. I need for blue one. Thanks
I should have added. These are 9/16" tall measuring the flaps that slide into the molding x 15/16" long (length probably wont matter as much as long as they lock onto the studs and hold the molding to the body).
I believe it is six, I would have to remove the molding again to check. I'm afraid to break the only remaining original one that is actually holding it on until I have a replacement that looks like it will work (by comparison to the old one).
Found the website. Did not see those (fa 423 listed). They had some listed as original part number matching dodge parts catalog. Did not look the same (no hole in middle for stud to slide/lock onto). Were listed as discontinued. Sent them an e-mail. Hope to hear back sometime soon. Thanks again...
looking for 'DART" emblems it is then. Thanks.
Googled Mr. G's and FA 423. Got nothing related. Are you referring to clip/retainers. If so would you part with a few? How much shipped?
71' swinger. molding runs the length of car. Someone walked by and the front fender molding caught on their cloths and pulled off. I have been to many body/paint/etc. shops trying to find a suitable replacement. Pics attached. Black clip is original? If not original works very well. White clip...
Sorry. I meant to post that I need a 71-72 manual steering preferably floor shift column or manual shaft. Have a power steering unit in one 71 swinger and hate it (have driven many and all have terrible road feel at speeds, dangerous above 100mph on bad roads; sorry a habitual offender). Been...
I need motor mount to install a 360 in place of 318. I believe I need a left (driver) side 360 motor mount. Somebody correct me if I am wrong. Sell me one If I am right. I also need the cam card for a MP 292H cam with .508/.508 lift.