Search results for query: *

BP did your radiator ship yet? I tried to snag that one on Saturday, everything else shoes pending, but no radiator yet

on the stand and in the car

pm sent

picked up a set of shocks and a trans temp gage, also found out I should get new wiper blades for the Cuda

try Paul at Liberty in Mt. Clemens 586 469-1140 they turned mine around in 3 or 4 weeks last year..

Fat fingers while scrolling

Before you do a compression check you should correct the throttle opening

I’ll be there with the Barracuda

The base is a fiberglass replica of the TA/AAR set up I purchased years ago from Year One and the seal I also purchased from Year One. It just slips over the lip of the base.

here’s a few more

step #11 use three self tapping #20Torx screws to attach housing.

see step #9 in the instructions https://www.jegs.com/InstallationInstructions/300/350/350-1478.pdf

here’s a 1405 w/electric choke

Does anyone have dimensions or a drawing for the location of the side marker lights on a 68 Barracuda? Thanks.

Here’s a copy of the write up in High Performance Mopar January’92 and here’s a link to a YouTube of it...

If I recall it’s in the baseplate front going into the primarys. I have the write up out in the barn, I’ll check it out this afternoon..

depending on your first gear, 3.09 I’d go with the 3.23, if it’s 2.66 then a 3.55. Would be the way to go, that’s with 27-28” rear tires.

On my most recent purchase, ‘67 Barracuda convert., replaced ignition box due to a miss above 4000rpms, then replaced non working radio with am/fm/Bluetooth unit, next swapped out the 2.76 peg leg for 3.23 suregrip and big bolt axles, fronts had wilwoods which have both bolt patterns,so a simple...

Also check eBay, sometimes they have had the wire harness cheaper than their 30% off price and free shipping

just got a YO 30% code good till saturday UC4302

looks like 2.47,1.77,1.34 & 1.00

Mancini’s also carries it, but you have to search for it. https://www.manciniracing.com/sapostpubr.html may have been on late ‘69s as they changed over. if you search ps008 you’ll find a few more vendors

https://bergmanautocraft.com/product/power-steering-pump-bracket-saginaw-type-67-69-small-block/ this will allow you to use the Saginaw pump on your cast iron water pump. Depending on the return outlet on the pump that line may be close to the exhaus, I put a heat sleeve on mine.

RIP Mike

DemonX check out post #45. Not the best pic but it should get the idea across

Tophat was right around 12 mile. We used to hang out at the Burger King @ 12 mile, also Eastgate shopping center @ Frazho. just before my cruising days was Jupiter’s in East Detroit, the saying was if you didn’t have over 400 cubes under the hood dont bother entering the lot..

$68 at amazon right now

Barracuda T on clearance @ Summit

Just a fyi for anyone interested

If you order one with the escape door check the distance to the bottom of the car door and make sure the opening in the trailer is low enough, otherwise you’ll have to raise the floor some. I ended up having to raise mine about 2” so I laid down a 2x12 and along with a piece of 3/4 plywood to...